C1334314 / P1334314
Threaded Backing Plates for replacing existing ø3-3/4 cup holders with ROUND Combination Rod & Cup Holders. These will NOT work for our Screwless Elite models. Use with Round Top SST Rod/Cup Holders only in an existing ø3-3/4 hole.
Step 1
USE THE BACKING PLATE (UPSIDE DOWN) TO MARK THE 3 MOUNTING HOLES
Step 2
DRILL WITH A SMALL DRILL ~ 1/8”. THEN USE A LARGER DRILL, IDEALLY 9/32”. IF THERE IS NOT ENOUGH MATERIAL TO DRILL THE LARGER HOLES JUST USE A ROUND FILE.
Step 3
INSERT BACKING PLATE INTO THE LARGE HOLE. USE MASKING TAPE TO TEMPORARILY HOLD WHILE YOU GET THE THREE SCREWS STARTED. LUBRICATE THE SCREW THREADS WITH ANTI-SEIZE, TEF- GEL, WD-40 OR SIMILAR TO AVOID THE THREADS FROM GALLING.
Step 4
REMOVE THE TAPE. SEAL WITH SILICONE IF YOU CHOOSE. DO NOT USE ANY OTHER TYPE OF SEALANT ON ABS PLASTIC.
HAND TIGHTEN THE THREE SCREWS.
ENJOY!!!